Try this build please:
2 Likes
can we have a updated lavender build please?
1 Like
Update for /e/OS-T 3.3:
4 Likes
works! dirrty flash.
1 Like
Works for me too, dirty flash too.
Thanks a lot for your work, especially because it’s the 3.3 version of /e/ OS! 
1 Like
Just like everyone else, latest build works a treat.
Does anybody else have an issue with vibration? On my own device aswell as one i was given to install e/os the vibration doesent work at all if its fine for other users i guess i have two faulty devices on my hand.
1 Like
hmm….i have 2 lavender.
one daily driver about 6 years in use my be. there virbration works with e/os 3.3.
another device was rescued from trash and i replaced display and USB pcd where also the virbrator is connected. on this unit vibration doesnt work. as said this might be caused by the usb repair (but i dont care).
Thanks for letting me know! It looks like the vibration works when it wants on one device and the other its completely dead, i guess its a common fault with this model, everything good with this build.
Also thanks for keeping devices out of the trash i do the same.
1 Like
You mentioning the USB board helped me find this…
Looks like possible pry damage, those are 0Ω resistors and they do connect on the vibration motor pads, i did solder this correctly and vibration works now.
I also checked the motor by applying 5volts to it and it was spinning fine, im posting this in case it helps somebody.
1 Like
This topic was automatically closed after 365 days. New replies are no longer allowed.