Mhm, bad. sorry, so for me is this case closed, because I can’t see a way to ehlp further. Sorry
Thanks for all your hard work, very much appreciated
OK, last 3 days I have tried to flash eGSI on my new Mi Max 3 nitrogen. And … it’s running. I think I found some point which you can also try.
-
Treble Info has shown that I do have an arm64 a/b device. But I have to flash the a_only GSI !!!
-
And after flashing the GSI I have to change to vbmeta.img. You will find the image here
thanks to Phh for this tip and command -
Download e-pie-20200416-UNOFFICIAL-treble_arm64_aeN.img.zip
-
extract this zip. It will generate a 2GB img file
-
download vbmeta.img
-
boot your device in recovery and FORMAT data
-
boot your device in fastboot mode (bootloader)
-
run theses commands in terminal
a) fastboot erase system
b) fastboot flash system e-pie-20200416-UNOFFICIAL-treble_arm64_aeN.img
c) fastboot --disable-verity --disable-verification flash vbmeta vbmeta.img
d) fastboot reboot
and now your system show boot into eOS … i hope
my terminal log you will find here for comparing.
Good luck
Wow! That sounds promising. I’m downloading now, thanks!
Boots to a black screen again for me
I can’t boot into the installed recovery too, I have to fastboot boot twrp.img then flash twrp again to gain recovery
but you have had it’s once booted in bouncing E, or not ? Try that version again, but with vbmeta flashing behind.
GSI’s have never booted for me. Just black screen after the device reboots.
Following your steps above using the 04-16 a only build with the vbmeta.img produce the same results
ok, now I’m really at the end
Thanks for trying @harvey186
I’m hoping the device will go official with 17.1 and hopefully make building a bit easier